Toshiba TDP-WX5400U 소유자 매뉴얼 - 페이지 21

{카테고리_이름} Toshiba TDP-WX5400U에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba TDP-WX5400U 42 페이지. Toshiba tdp-wx5400: user guide
Toshiba TDP-WX5400U에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지)

페이지 인쇄

Basic operations (Continued)

To alter the picture size,

press Menu and select the

[Adjust] menu using p or

q. Press Enter to open the

[Adjust] menu. Press t or

u to select [Display setting]

followed by p or q to select

[Screen]. Press Enter.

The [Screen] window is

displayed. Select the desired

picture size using p or q

and press Enter.

When finished, press

[Return] to go back to the

projected image.

Adjusting the volume

The volume can be adjusted with the

remote control unit.

Press the Vol +/- buttons

on the remote control. The

volume bar is displayed on

screen.

Use the Vol +/- buttons to adjust the level.

Notes

•

Volume can also be adjusted from the Volume in the Menu.

Notes

•

Note that lamp characteristics may rarely cause the brightness to fluctuate slightly.

•

A lamp is consumable item. If used for extended periods, images will appear dark, and the

lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The lifetime of

the lamp depends on conditions of use.)

•

The DLP

chip is made using extremely advanced technology, but there may be black spots

(pixels that do not light) or bright spots (pixels that are constantly lit) on the panel. Please

note that these are not malfunctions.

•

Although this projector supports a wide range of RGB signals

supported by this projector (WXGA) will be expanded or shrunk, which will affect image

quality slightly. To view high-quality images, it is recommended that the computer's

external output should be set to WXGA resolution.

•

With some models of computer having LCD displays or the like, displaying images

simultaneously on the projector and the monitor's display may prevent the images from

displaying properly. If this happens, turn off the computer's LCD display. For information on

how to turn off the LCD display, see the owner's manual of your computer.

•

If no signal is being input from the connected equipment or signal input is stopped while

projecting, the "No signal" will appear.

•

If a signal not supported by the projector is input, "No signal" message will appear.

•

If an unavailable operation button is pressed, "This function is not supported" will appear.

, any resolutions not

p.78