Toshiba TLP-ET1U 소유자 매뉴얼 - 페이지 45
{카테고리_이름} Toshiba TLP-ET1U에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Toshiba TLP-ET1U 50 페이지. 3lcd projector
페이지 인쇄
Others
Trouble indications
The indicator lights inform you of internal abnormalities.
ON
LAMP
TEMP
FAN
(Off)
ON
LAMP
TEMP
FAN
(Red lit) (Red lit)
(Green lit)
ON
LAMP
TEMP
FAN
(Red lit)
(Red lit
(Green lit)
or flashing)
or
(Orange lit or flashing)
or
(Green lit)
ON
LAMP
TEMP
FAN
(Red lit)
(Red lit
or flashing)
or
(Orange lit
or flashing)
or
(Green lit
or flashing)
ON
LAMP
TEMP
FAN
(Red lit) (Orange
(Green lit)
flashing)
PRECAUTIONS
• Make sure to unplug the power cord if something goes wrong.
• If the power cord is unplugged before cooling is complete, give the lamp enough time to cool before plugging
it back in. If the lamp overheats, it may fail to light. Unplugging the power cord repeatedly when the tempera-
ture is high will shorten the life of the lamp. (Even if you are not concerned about lamp lifetime, the light may
not come on if you do not wait for at least three minutes.)
No power
⇒ Problem with projector
• Unplug the power cord, and contact your dealer.
Lamp went out during use
⇒ Lamp temperature is high so that it is difficult to turn on, the lifetime of the lamp
has ended, or the projector is malfunctioning.
• Unplug the power cord and wait for a short while, then turn the power back on.
• If a lamp burns out, replace it with a new one.
❈
After approx. one minute of abnormal display, the projector returns to the
standby state waiting for internal cool down.
Power went out during use, or won't come on
⇒ Internal overheating, or the outside temperature is too high.
• Replace the projector so that the air intake and exhaust are not blocked.
• Unplug the power cord and wait for a short while, then turn the power back on.
• Clean the air filter. (See
❈
The
icon will appear before the power goes out.
❈
After approx. two minutes of error display, the projector returns to the standby
state waiting for internal cool down.
Power went out during use, or won't come on
⇒ Problem with internal cooling fan.
• Unplug the power cord, and contact your dealer.
❈
The
icon will appear before the power goes out.
❈
After approx. one minute of abnormal display, the projector returns to the
standby state waiting for internal cool down.
Power went out during use
⇒ The lamp cover is not properly attached.
• Unplug the power cord, and reattach the lamp cover. (See
❈
After approx. one minute of abnormal display, the projector returns to the
standby state waiting for internal cool down.
p.40.)
p.42.)
45