3Com EtherLink 3C905C-TX-M 빠른 매뉴얼 - 페이지 9
{카테고리_이름} 3Com EtherLink 3C905C-TX-M에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com EtherLink 3C905C-TX-M 15 페이지. Network interface card
페이지 인쇄
rn_body.SML Page 7 Wednesday, June 9, 1999 7:56 AM
Installing the Network Driver
This section describes how to install the network driver on a
PC running Windows 95, Windows 98, or Windows NT 4.0.
For other operating systems, see the user guide on
the EtherCD.
Before installing the network driver:
Make sure that you have run the preinstallation program.
I
Make sure that the NIC is installed in the PC and
I
that it is connected to the network.
Make sure you have the Windows installation files
I
(Windows 95/98 only). These files may be on a CD or
they may have been copied to your hard drive when
Windows was installed on the PC.
Windows 95
To install the network driver:
1 Turn on the power to the PC.
Windows 95 detects the NIC. The Insert Disk dialog box
appears, prompting you to insert the EtherCD.
If the New Hardware Found screen appears or the
Update Device Driver Wizard starts, the NIC preinstallation
program was not run on the PC. Follow the instructions in
the W95NDIS.TXT file located in the Help directory on the
EtherCD to continue the installation.
2 Make sure that the EtherCD is inserted in the
CD-ROM drive.
3 Click OK.
The Copying Files dialog box appears.
4 Open the pull-down menu and select:
c:\windows\options\cabs
5 Click OK.
Files are copied.
If this is the first time that networking is being installed
I
on your PC, the Identification tab of the Network screen
appears. Go to
If networking has already been installed, you are
I
prompted for the Windows 95 CD. Go to
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
Installing the Network Driver
step
6.
7
step
7.