Aeotec Water Sensor 7 Pro 사용자 설명서 - 페이지 13
{카테고리_이름} Aeotec Water Sensor 7 Pro에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec Water Sensor 7 Pro 14 페이지. Water sensor
Aeotec Water Sensor 7 Pro에 대해서도 마찬가지입니다: 매뉴얼 (3 페이지), 빠른 시작 매뉴얼 (8 페이지), 사용자 설명서 (9 페이지), 사용자 설명서 (13 페이지), 사용자 설명서 (9 페이지)
페이지 인쇄
Tilt
0x0B
4.10 CENTRAL SCENE
When activated by configuration parameter #14 the device can perform as a scene controller. Digital + VCC is used to
connect the scene button. The external dry contact will then act as a scene controller with a total of 7 scenes that can
be activated:
• 1 - Contact Pressed 1 time
• 2 - Contact Pressed 2 time
• 3 - Contact Pressed 3 time
• 4 - Contact Pressed 4 time
• 5 - Contact Pressed 5 time
• 6 - Contact held down
• 7 - Contact released
Slow Refresh = 0, A new Key Held Down notification will be sent every 200ms until the key is released.
4.11 Wake Up
Parameter
Min Wake Up Interval Seconds
Max Wake Up Interval Seconds
Default Wake Up Interval Seconds
Wake Up Interval Step Seconds
4.12 Battery
The 2.90V or more battery voltage corresponds to 100% battery level, and 2. 60V or less corresponds to 0%.
1.
If send Battery Get to the device, it will issue Battery Report with battery level to the requester when waked up.
2.
If waked up or power on, it will detect battery level, and issue Battery Report 0xFF via Lifeline when battery level is
3.
less than the value of configuration parameter 23 .
If the battery level is less than the value of configuration parameter 23 , LED will flash red 3 times for each waked up .
4.
4.13 Indicator
Indicator ID
Node Identify
(Green Led)
AEOTEC User Manual
0x00 / 0xFF
Value
0x000E10
0xEFF100
0x093A80
0x0000F0
Property ID
0x50
On Off Period
On Off Cycles
On time within an On/Off period
tilt event
Page 10
Time
3600s [1 hour]
15724800s
604800s [1 week]
240s [4 minutes]
0x03
0x04
0x05