Aeotec ZW187 매뉴얼 - 페이지 7

{카테고리_이름} Aeotec ZW187에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec ZW187 11 페이지. Recessed door sensor gen7
Aeotec ZW187에 대해서도 마찬가지입니다: 사용자 설명서 (9 페이지)

페이지 인쇄
Aeotec ZW187 매뉴얼
Security Class
SmartStart Compatible
Over The Air (OTA)
Multi Channel Device
Association
Factory Reset
Power-down Memory
Timed battery report
Low battery warning
Sensor State Report
Control other device
AEOTEC Engineering Specification
Non-Security, S0, S2 Unauthenticated, and S2 Authenticated
Support. After powering on, SmartStart is auto activ ated if it 's out of the Z-Wave network.
Support. Firmware can be updated via RF.
No
Support. Refer to Section 4.7 Association Group Info.
Support. Refer to Section 3.6 How to factory reset.
Support. All command settings will stay unchanged even power down.
Support. Refer to Configuration Parameter 101.
Support. Refer to Configuration Parameter 90.
Support. When Magnet is away or near, send out notification via Group 1 .
Support. When Magnet is away or near, control other Z -Wave device directly via Group 2.
Page 3