Aeotec MultiSensor 7 사용자 설명서 - 페이지 4

{카테고리_이름} Aeotec MultiSensor 7에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec MultiSensor 7 5 페이지.
Aeotec MultiSensor 7에 대해서도 마찬가지입니다: 사용자 설명서 (8 페이지)

페이지 인쇄

3. It will be solid

yellow

during inclusion, and flash

Advanced Functions.

Z-Wave Resetting MultiSensor 7.

Your MultiSensor can be removed from your Z-Wave network at any time. You'll need to use your Z-Wave network's main controller to do this and the follo

this. If you are using other products as your main Z-Wave controller, please refer to the part of their respective manuals that tells you how remove devices

Using an existing gateway:

You may need to refer to your gateway's method of including devices if you do not know how to pair a Z-Wave device. You may use any gateway to pe

MultiSensor 7 even if they are not paired together to factory reset MultiSensor 7.

1. Set your Z-Wave gateway into Z-Wave unpair (exclusion) mode.

2. Tap the action button once; the

3. If removed successful, the

Manual Hard Resetting MultiSensor 7.

This method is not fully advised unless your gateway has failed, if paired to your network, performing these steps will factory reset your MultiSensor 7, but

phantom/ghost device in your working Z-Wave network.

1. Make sure the device has been powered.

2. Press and hold the button for 20 seconds. When the red led flash, the device will enter factory reset mode.

white/green

3 times if paired successfully. If it fails, it will flash

purple

led will light up.

blue

led will fade in and out to indicate it is ready to be paired to a new hub.

white/red

instead.