Aeotec MultiSensor 7 사용자 설명서 - 페이지 5

{카테고리_이름} Aeotec MultiSensor 7에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeotec MultiSensor 7 5 페이지.
Aeotec MultiSensor 7에 대해서도 마찬가지입니다: 사용자 설명서 (8 페이지)

페이지 인쇄

1. Press and hold Multisensor 7 Action button

2. Wait until the LED turns into a solid orange color (2 - 5 seconds)

3. Release Multisensor 7 Action Button, the LED should remain solid

If the MultiSensor 7 LED

1-3 again, then power up your hub again.

4. Tap the Action Button on Multisensor 7 to put Multisensor 7 back to sleep, or wait 5 minutes. (recommended to manually put it back to sleep to co

Advanced settings of MultiSensor 7.

There are further advanced parameter settings and group association settings not listed in this guide. You can find the attachment of the advanced engine

which will give you all possible functions of the MultiSensor 7 that may be missing in this guide.

The PDF guide will feature these missing advanced settings:

Parameter settings (Configuration Command Class)

Group Association (Association Command Class)

You may download the engineering sheet below:

orange

LED turns off right away, this would indicate that your hub is putting your device to sleep. Try unpowering yo

while it is awake. Send any configurations from your hub (assuming th