Whirlpool DryAire LMA1053L 매뉴얼 - 페이지 19

{카테고리_이름} Whirlpool DryAire LMA1053L에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool DryAire LMA1053L 32 페이지. Drying cabinet
Whirlpool DryAire LMA1053L에 대해서도 마찬가지입니다: 매뉴얼 (32 페이지)

페이지 인쇄

REMOVING THE BLOWER ASSEMBLY,

THE THERMOSTAT & TEMPERATURE SENSOR

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before

operating.

Failure to do so can result in death or

electrical shock.

NOTE: Sharp edges may be present.

Disconnect the power to the drying cabi-

net.

Remove the component panel (see page

4-2 for the procedure).

To remove the blower assembly:

a) Disconnect the wires from the fan mo-

tor terminals.

b) Remove the four screws from the

blower assembly and remove it.

Blower Assembly

2 Screws

To remove the thermostat and tem-

perature sensor:

a) Remove the two mounting screws and

lockwasher from the shield and remove

the shield from the component panel

(see the photo in step 3 on the previ-

ous page).

2 Screws

Fan Motor Wires

b) Remove the knob from the thermostat

control shaft.

c) Remove the two screws and lock-

washers from the thermostat.

d) Disconnect the wires from the thermo-

stat terminals.

e) Slide the sensor tube out of the slotted

rubber grommet, and then pull the end

of the sensor from the other rubber

grommet.

Temperature

Sensor

Sensor Tube In

Slotted Grommet

4-5

Thermostat Knob

Thermostat Screws/

Lockwashers

Thermostat

Wires