Whirlpool DryAire LMA1053L 매뉴얼 - 페이지 20
{카테고리_이름} Whirlpool DryAire LMA1053L에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool DryAire LMA1053L 32 페이지. Drying cabinet
Whirlpool DryAire LMA1053L에 대해서도 마찬가지입니다: 매뉴얼 (32 페이지)
페이지 인쇄
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
NOTE: Sharp edges may be present.
1.
Disconnect the power to the drying cabi-
net.
2.
Remove the component panel (see page
4-2 for the procedure).
Relay
3.
Remove the two mounting screws and
lockwasher from the shield and remove
the shield from the component panel.
Shield
Screw
REMOVING THE RELAY
Screw &
Lockwasher
4-6
4.
Push down on the top of the relay case and
rotate the lower rear up to unclip the relay
from the front panel.
Push Down On Front Of Relay Case
Rotate Bottom Of Relay Case Up
5.
One at a time, loosen a wire setscrew and
pull the wire(s) out of the relay connector.
Connect the end of the wire(s) to the
terminal with the same letter/number
callout on the replacement relay. This will
help you rewire the new relay properly.
Terminal
Screw