ABB FDNA-01 빠른 설치 및 시작 매뉴얼 - 페이지 2

{카테고리_이름} ABB FDNA-01에 대한 빠른 설치 및 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB FDNA-01 2 페이지. Canopen adapter module
ABB FDNA-01에 대해서도 마찬가지입니다: 빠른 설치 및 시작 매뉴얼 (2 페이지)

페이지 인쇄
ABB FDNA-01 빠른 설치 및 시작 매뉴얼
Pin allocation for [X1]
1 2 3 4 5
Pin
Description
1
V-
Network power supply
ground (0V DC)
2
CAN_L
CAN_L bus line
3
SHLD
Network cable shield
4
CAN_H
CAN_H bus line
5
V+
Network power supply
source (24V DC)
Start-up
When the module is connected to the drive, the drive control program sets the applicable parameters.
See the appropriate drive manual.
Basic parameter settings
Index
Name
20.01
Ext1 commands
22.11
Speed ref1 source
28.11
Frequency ref1 source
50.01
FBA A enable
50.02
FBA A comm loss func
51.02
MAC ID
To take the settings into use, validate and refresh the parameters with parameter 51.27 FBA par refresh.
Further information
See the latest version of FDNA-01 DeviceNet adapter
module user's manual (3AFE68573360 [English]) in ABB
library (www.abb.com/drives/documents)
FDNA-01 manual
3AXD50000158515 Rev A (EN) 2017-11-23
Bus termination
The module does not provide bus termination. The DeviceNet
network should be terminated at both ends of the trunk cable with
a 121 ohm, ¼ W, 1% metal film resistor.
Connect the resistor between the two signal wires (CAN_H,
CAN_L) on the DeviceNet cable, as shown in this figure.
Scanner
121
1%
Metal Film
1/4 W
Value
Fieldbus A
FBA A ref 1
FBA A ref 1
Enable (or select the option slot in which the module is installed).
This activates the communication module. The HOST LED becomes green.
Fault
Set the MAC ID number for the drive.
For more information on fieldbus options and protocols
provided by ABB Drives, see the fieldbus
communications web page
.
(new.abb.com/drives/connectivity/fieldbus-connectivity).
...
Node 1
CAN_H
CAN_L
Fieldbus communications web page
Node n
121
1%
Metal Film
1/4 W