Whirlpool LI3YRB 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 8

{카테고리_이름} Whirlpool LI3YRB에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool LI3YRB 28 페이지. 36" (91.4 cm) island-mount canopy range hood

페이지 인쇄

5. Attach the horizontal support (B) using 8 - 4 x 8 mm screws.

A. Vertical supports

B. Horizontal support

C. Notched end

6. Attach a second set of vertical supports (A) and set the

vertical height (B). See "Installation Dimensions" in the

"Location Requirements" section to help determine the

desired dimension for vertical height "B."

A. Vertical supports

B. Vertical height

Install Range Hood

Non-Vented (recirculating) Installation

1. Attach the air deflector to the upper horizontal support using

4 mounting screws.

A. Deflector

B. Mounting screws

2. Measure the length of 6" (15.2 cm) duct needed to connect

the transition to the deflector.

NOTE: Vent should fit up inside the deflector 1" (2.5 cm)

minimum.

3. Install vent between the transition and the deflector.

NOTE: To make vent installation easier, temporarily remove

the deflector from the chimney support bracket and replace

after vent section is in place.

4. Seal all connections with vent clamps. Continue with "Range

Hood Installation" in this section.

Range Hood Installation

1. Using 2 or more people, lift the range hood assembly and

attach it by snapping the vertical supports to the spring clips

in the upper horizontal support bracket that is mounted to the

ceiling.

2. Install 16 - 4 x 8 mm screws and tighten to secure.

A. Mounting screws

Connect Vent System

1. Install vent system.

2. Push duct over the exhaust outlet. Seal all connections with

vent clamps.

3. Use caulk to seal all openings.

Make Electrical Connection

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

1. Disconnect power.

2. Remove terminal box cover.

3. Remove the knockout in the terminal box cover and install a

UL listed or CSA approved ¹⁄₂" strain relief.

A. Knockout

B. Terminal box cover