Whirlpool LI3YRB 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 9

{카테고리_이름} Whirlpool LI3YRB에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool LI3YRB 28 페이지. 36" (91.4 cm) island-mount canopy range hood

4. Run home power supply cable through strain relief, into

terminal box.

A. Home power supply cable

B. UL listed or CSA approved strain relief

C. Black wires

D. UL listed wire connectors

E. White wires

F. Green (or bare) and yellow-green ground wires

5. Use UL listed wire connectors and connect black wires (C)

together.

6. Use UL listed wire connectors and connect white wires (E)

together.

WARNING

Electrical Shock Hazard

Electrically ground blower.

Connect ground wire to green and yellow ground wire

in terminal box.

Failure to do so can result in death or electrical shock.

7. Connect green (or bare) ground wire from home power supply

to yellow-green ground wire (F) in terminal box using UL listed

wire connectors.

8. Tighten strain relief screw.

9. Install terminal box cover.

10. Check that all light bulbs are secure in their sockets.

11. Reconnect power.

NOTE: Remove the film from the vertical duct cover supports and

the duct covers.

1. Attach the vertical duct cover supports using 8 - 4 x 8 mm

2. Slide the upper duct covers into place, and insert 3 tabs on

3. Slide the lower duct covers over the upper duct covers.

4. Attach the lower duct covers together using a plastic bracket

Install Duct Covers

screws.

A. Screws

B. Vertical duct cover support

each side of the duct covers into the mating slots of the

vertical duct cover supports. Slide the duct covers up until

the springs "click" and the tabs are locked in place.

A. Upper duct cover

B. Spring

at each top and bottom corner of the lower duct covers

(4 places).

A. Upper duct cover

B. Lower duct cover

C. Plastic brackets