Whirlpool LI3YRB 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 7

{카테고리_이름} Whirlpool LI3YRB에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool LI3YRB 28 페이지. 36" (91.4 cm) island-mount canopy range hood

페이지 인쇄

Range Hood Mounting Screws Installation

1. Determine and mark the centerline on the ceiling where the

range hood will be installed, considering the requirements for

ceiling support structures. See the "Location Requirements"

section. Make sure the range hood is centered over the

cooking surface.

2. Tape template in place on the ceiling at the marked

centerline. The line for the front of the range hood should be

parallel to the front of the cooktop.

3. Use a pencil to mark the mounting screws, wire access and

duct hole locations on the ceiling.

NOTE: Mounting hole locations should be into a ceiling

support structure capable of holding 80 lbs (36.6 kg).

Remove the template.

4. Drill 4 - ³⁄₁₆" (4.8 mm) pilot holes for mounting the upper

horizontal support.

Complete Preparation

1. Determine the required location for the home power supply

cable and drill a ½" (1.3 cm) diameter hole for wire access.

2. Run ½" (1.3 cm) conduit and wires or home power supply

cable according to the National Electrical Code or CSA

Standards and local codes and ordinances. There must be

enough ½" conduit and wires or home power supply cable

from the fused disconnect (or circuit breaker) box to make the

connection in the hood's electrical terminal box.

NOTE: Do not reconnect power until installation is complete.

3. For vented installations only: Using a jigsaw or keyhole

saw, cut a 6½" (16.5 cm) diameter hole for the vent duct.

4. Attach the upper horizontal support bracket with 4 - 5 x

45 mm wood screws.

NOTE: Upper horizontal support screws must be into a

ceiling support structure capable of holding 80 lbs (36.6 kg).

A. Upper horizontal support

Assemble Range Hood

1. Assemble rubber seals to the front and back flange of the

ventilator assembly.

A. Rubber seal

2. Assemble and center glass canopy to ventilator assembly.

NOTE: The range hood should be sitting on covered spacers

for assembling the glass canopy to the ventilator assembly.

A. Covered spacers

B. Glass canopy

C. Ventilator assembly

3. Install retainer bracket to both sides and secure with 4 - 4 x

8 mm screws to hold glass canopy to ventilator assembly.

A. Retainer bracket

B. Glass canopy

C. Ventilator assembly

4. Position the 4 vertical supports (A) with the notches at the

bottom and attach to the range hood using 16 - 4 x 8 mm

screws.