Whirlpool Ventilation Hood 설치 및 사용 설명서 - 페이지 4
{카테고리_이름} Whirlpool Ventilation Hood에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool Ventilation Hood 32 페이지. Island canopy range hood
Whirlpool Ventilation Hood에 대해서도 마찬가지입니다: 사용 설명서 (7 페이지)
페이지 인쇄Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the safety instructions provided with any tools
listed here.
Tools needed:
level
drill with 1 " (3.2 cm),
" (3 mm) drill bits
pencil
wire stripper or utility knife
measuring tape or ruler
pliers
caulking gun and weatherproof caulking compound
duct tape
jig saw or keyhole saw
flat blade screwdriver
metal snips
Phillips screwdriver
Parts needed:
1 x
" conduit
1 roof cap
metal vent system
charcoal filter – for non-vented (recirculating)
installations only
Parts supplied:
Remove parts from packages. Check that all parts were included.
hood canopy assembly with ventilator, light bulbs and
transition with back draft dampers installed
deflector for non-vented (recirculating) installations
Installation Instructions and Use & Care Guide
filter – installed in hood canopy
screws and drywall anchors
mounting template
4 vent covers with 4 trim pieces
4
INSTALLATION REQUIREMENTS
" (9.5 mm),
" (2.75 mm) and
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
Canopy hood location should be away from strong draft areas,
such as windows, doors and strong heating vents.
Grounded electrical outlet is required. See "Electrical
Requirements" section.
The hood must be fastened to solid wood.
The island hood is factory set for venting through the roof or wall.
For non-vented (recirculating) installations see "Non-vented
(recirculating) installations" in "Hood Frame Assembly" section.
All openings in ceiling where canopy hood will be installed must
be sealed.
Product Dimensions
(34 cm)
43
23 "
(60 cm)
15"
13 "
(38.1 cm)
23
(59.5 cm)
" (110 cm)
31 "
(79.1 cm)
min.
42 "
(108 cm)
max.
"