AER Domino 2A 사용자 설명서 - 페이지 9

{카테고리_이름} AER Domino 2A에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AER Domino 2A 16 페이지.
AER Domino 2A에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지), 사용자 설명서 (20 페이지)

페이지 인쇄

General Note: Use of 48V or 24V phantom

power

(Phantom power = remote supply, here: powering

an audio device via the connected audio line)

Turn on the phantom power only if the unit con-

nected to the XLR sockets of channels 2 and 3/4 is

designed to handle it!

In general, suitable units are e.g. condenser micro-

phones, active DI-boxes and other special audio

devices, whose power supply is drawn from the

phantom power. Such devices are also labelled ac-

cordingly; please heed the permissible power con-

sumption (max.10mA).

High-quality dynamic microphones with a balanced

signal need no phantom power, but can handle it

anyway.

Other devices, which have not been designed expli-

citly for phantom power operation, can suffer from

considerable malfunctions and damage may result

as well.

Examples of devices that may be damaged by in-

correct application of phantom power include:

Low-cost dynamic microphones with a mono jack-

plug (unbalanced signal) that were fitted afterwards

with an XLR connector.

Audio devices with a balanced XLR output (e.g. DI-

boxes, effects devices, instrument preamps with

a DI output etc.) which are not protected against

phantom power applied to their XLR output. (The

DI connectors on AER products are protected

against applied phantom power.)

Other audio devices (such as preamps, effects pe-

dals etc.) whose unbalanced line output was repla-

ced by an XLR socket.

If in doubt please consult the manufacturer of the

device you are using.

5.4 Phantom power

Microphones requiring 48V phantom power can be

directly connected to the XLR sockets of channels 2

and 3/4. The phantom power can be switched on and

off via the 48V-switch.

The jack sockets of channel 1 and 3/4 can additio-

nally be supplied 15V-Phantomspeisung by an in-

ternal jumper.

Please note: For these alterations the device must

be opened, therefore only qualified service person-

nel may carry out the modifications concerning the

activation of phantom power.

5.5 Stereo-Simulation

The Domino

is mono – thus L-out and R-out are

2.A

carrying the same output-signal. You can use these

sockets to connect additional active AER fullrange-

systems (e.g. AG 8

, CX 8, AS Q8, AS 281), whose levels

are adjusted by the pre master-control independent

of the overall volume (master) of your Domino

activating the stereo-simulation (stereo sim.-switch

pressed), a stereo-like, wider sound impression is ge-

nerated.

On stage (Domino

as monitor) the sound remains

2.A

unchanged..

. By

2.A