Firesense 61322 매뉴얼 - 페이지 10

{카테고리_이름} Firesense 61322에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Firesense 61322 14 페이지. Outdoor tabletop heater

페이지 인쇄

OPERATING INSTRUCTIONS

OPERATION CHECKlIST:

For a safe and pleasant heating experience, perform this check

before each use:

BEFORE OPERATING:

I am familiar with entire owner's manual and understand all

precautions noted.

All components are properly assembled, intact and operable.

No alterations have been made.

All gas connections are secure and do not leak.

Wind velocity is below 10 mph.

Heater is for use outdoors (outside any enclosure).

There is adequate fresh air ventilation.

Heater is away from gasoline or other flammable liquids or vapors.

Heater is away from windows, air intake openings, sprinklers and

other water sources.

Heater is at least 18 in. on top and at least 24 in. on sides from

combustible materials.

Heater is on a hard and level surface.

There are no signs of spider or insect nests in heater orifices.

All burner passages are clear.

All air circulation passages are clear.

Clothing or other protective material should not be hung from the

heater, or placed on or near the heater.

Any guard or other protective device removed for servicing the heater

must be replaced prior to operating the heater.

Installation and repair should be done by a qualified service person.

The heater should be inspected before each use and at least annually

by a qualified service person.

OPERATION INFORMATION AND SAFETY:

• Unit will operate at reduced efficiency below 40 degrees F.

• Children and adults should be alerted to the hazards of high surface

temperatures and should stay away to avoid burns or clothing

ignition.

•

Young children should be carefully supervised when they are in the

area of the heater.

• More frequent cleaning may be required as necessary. It is

imperative that control compartment burner and circulating air

passageways of the heater be kept clean and free of debris and/or

spider or insect nests.

WARNING

FOR YOUR SAFETY

Heater will be hot after use. Handle with

extreme care.

SHUT DOWN:

1. Turn control knob

clockwise to OFF while

depressing the knob.

(Burner may make a slight

popping noise when

extinguished).

2. Disconnect gas tank

when heater is not in use.

NOTE: After use, some

discoloration of the

emitter screen is normal.

AFTER OPERATION:

1. Gas control knob is in

OFF position.

2. Gas tank valve is OFF.

3. Disconnect gas line.

4. Heater is stored upright

in a secure location.