Firesense 61322 매뉴얼 - 페이지 8

{카테고리_이름} Firesense 61322에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Firesense 61322 14 페이지. Outdoor tabletop heater

OPERATING INSTRUCTIONS - SAFETY FIRST

Read and become familiar with this entire manual, especially the

following precautions:

Caution: This appliance is for outdoor use only (outside any enclosure). Always

make sure there is fresh air ventilation.

• Use only outdoors in a well ventilated space. Never use in a building, garage or

any other enclosed area.

• Always maintain at least 18" clearance (top) and 24" clearance (sides) from

combustible materials.

• Always place heater on a hard and level surface.

• Do not use if the wind velocity is greater than 10 miles per hour.

• Unit will operate at decreased efficiency below 40 degrees F (5 degrees C).

• Keep sprinklers and other water sources away from burner and controls.

• Always use extreme caution when near heater. Alert both children and adults

to the hazards of high temperatures, especially to avoid burns or clothing

catching fire.

• Young children and pets should be carefully supervised when they are in the

area of heater.

• Do not place clothing or other flammable materials on or near heater.

• Any guard or other protective device removed for servicing the heater must be

replaced prior to operating the heater.

• Certain materials or items, when stored under heater, will be subjected to

radiant heat and could be seriously damaged.

• Do not alter heater in any manner.

• Inspect heater before each use. If a damaged part is detected, do not operate

until an original equipment replacement part has been properly installed. Use of

unauthorized parts will void warranty and create an unsafe condition.

• Do not attempt to use this appliance without a functional factory supplied gas

regulator in place. If regulator becomes damaged, use only a factory supplied

replacement.

• Prior to operating heater, replace any guards or protective devices removed for

servicing.

• During operation, do not touch burner assembly. The surface of heater's

emitter can reach temperatures approaching 1600 degrees F.

• After shutdown, do not touch burner assembly until heater has cooled

completely (approximately 45 minutes after use).