Firetide HotPoint 5100 하드웨어 설치 매뉴얼 - 페이지 15

{카테고리_이름} Firetide HotPoint 5100에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Firetide HotPoint 5100 19 페이지.
Firetide HotPoint 5100에 대해서도 마찬가지입니다: 매뉴얼 (2 페이지)

페이지 인쇄

Indoor access point installation

You need to install the access point in a permanent location that meets the

product's operational requirements and install the antennas correctly.

Appropriate locations for an indoor access point

You can install an indoor access point on a desk top or counter.

You can also attach the device to a wall or ceiling. When you intend to install the

device to a wall or ceiling, use the correct mount hardware.

Antenna installation

Follow the manufacturer's installation diagram or procedures that come with the

antenna that you want to use with the access point.

Recommendations for outdoor use

If you want to use this device in an outdoor environment, you need to use special

pigtails.

Operational requirements

The HotPoint 5100 access point operates within these environmental

constraints:

• Operating temperature: 0 °C to +50 °C (32 °F to +122 °F)

• Storage temperature: -20°C to +70 °C (-4 °F to +158 °F)

• Humidity (non-condensing): 10% to 90%

• Storage humidity (non-condensing): 10% to 90%

• Maximum altitude: 4572 m (5,000 feet)

Installing the mesh node in an enclosure

If you install an access point in an enclosure not manufactured by Firetide, the

installation is not supported.

Refer to the product operational requirements to make sure that the enclosure

you select is compatible with the operating environment required by the

HotPoint 5100 access point.