3Com OfficeConnect WX1200 빠른 시작 매뉴얼 - 페이지 5
{카테고리_이름} 3Com OfficeConnect WX1200에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com OfficeConnect WX1200 10 페이지. Secure converged networks enterprise edition
3Com OfficeConnect WX1200에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (2 페이지), 데이터시트 (6 페이지), 제품 설명서 (15 페이지)
페이지 인쇄
You can enable the switch to use the MSS DHCP
client to obtain this information from a DHCP server
in the local network where the switch will be
deployed. Alternatively, you can statically configure
the information.
The IP address and DNS information are configured
independently. You can configure the combination of
settings that work with the network resources
available at the deployment site. The following
examples show some of the combinations you can
configure.
Example 1: Deployment Site Has DHCP and Local
DNS The deployment site in this example has a
DHCP server. The switch is configured to use the MSS
DHCP client to obtain an IP address, default router
address, DNS domain name, and DNS server IP
addresses.
Configure a VLAN:
1
WX1200# set vlan 1 port 7
success: change accepted.
Enable the DHCP client on VLAN 1:
2
WX1200# set interface 1 ip dhcp-client enable
success: change accepted.
Enable the auto-config option:
3
WX1200# set auto-config enable
success: change accepted.
Save the configuration changes:
4
WX1200# save config
success: configuration saved.
Power off or restart the switch.
5
Remotely Configuring a Switch Using 3WXM (any model)
Example 2: Deployment Site Has No DHCP and
No DNS The deployment site in this example does
not have a DHCP server or a local DNS server.
Therefore, IP and DNS information must be statically
configured. Because no DNS server is available, an IP
alias is configured to map the IP address of the host
where 3WXM Services are installed to the well-known
hostname wlan-config-srv.
Configure a VLAN:
1
WX1200# set vlan 1 port 7
Configure an IP interface on the VLAN:
2
WX1200# set interface 1 ip 192.168.1.252
255.255.255.0
Configure a default route through the local default
3
router:
WX1200# set ip route default 192.168.1.1 1
Configure the default DNS domain name:
4
WX1200# set ip dns domain example.com
Configure an IP alias to map the 3WXM server IP
5
address to the well-known name wlan-config-srv:
WX1200# set ip alias wlan-config-srv
172.16.22.84
Enable the auto-config option:
6
WX1200# set auto-config enable
Save the configuration changes:
7
WX1200# save config
Power off or restart the switch.
8
5