Xerox WorkCentre Pro 65 시스템 관리 매뉴얼 - 페이지 17
{카테고리_이름} Xerox WorkCentre Pro 65에 대한 시스템 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox WorkCentre Pro 65 30 페이지. Pdl reference guide
Xerox WorkCentre Pro 65에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (16 페이지), 사용자 설명서 (24 페이지), 네트워크 설치 매뉴얼 (42 페이지), 참조 매뉴얼 (22 페이지)
페이지 인쇄
Universal Serial Bus Printing
Xerox WorkCentre Pro System Administration Guide Supplement
USB Printer Port
The USB Printer Port can be used for printing directly from a
PC connected via a USB cable. USB printing from Windows
98/Me/XP and 2000 is supported. The USB port for printing is
located on the network controller at the back of the machine
on the bottom left hand side, next to the Ethernet port.
Go to the WorkCentre Pro and...
1. Enter the Tools pathway.
a) Press the Access (
b) On the keypad enter 1111 or the current password.
Press Enter. The Touch Screen will be used for the
remainder of the data entry, unless instructed
otherwise.
2. Press More.
3. Press Connectivity and Network Setup.
4. Press Physical Media.
5. Press USB Printer Port.
6. Press Enable.
7. Use the up and down scroll arrows to select the setting
required for the Printer Port Timeout.
NOTE: The default Timeout value is 5 seconds. If you are
using an older PC and experience any print problems, you
may need to increase this value.
8. Press Save.
9. Press Exit Tools.
10. Verify the USB Print Kit has been installed and the USB
Printer Port has been enabled by printing a Configuration
Report. (For instructions click the Network Connectivity
tab and select Configuration Report from the menu list.)
On the Configuration Report, under Device Profile, USB
Printer Port should read Installed and the USB Printer
Port Settings: USB Port Enabled should read Enabled.
or
) button.
Page 1 - 5