Xerox WorkCentre Pro 65 Sistem Yönetimi Kılavuzu - Sayfa 17
Hepsi Bir Arada Yazıcı Xerox WorkCentre Pro 65 için çevrimiçi göz atın veya pdf Sistem Yönetimi Kılavuzu indirin. Xerox WorkCentre Pro 65 30 sayfaları. Pdl reference guide
Ayrıca Xerox WorkCentre Pro 65 için: Hızlı Başlangıç Kılavuzu (16 sayfalar), Kullanıcı Kılavuzu (24 sayfalar), Ağ Kurulum Kılavuzu (42 sayfalar), Referans Kılavuzu (22 sayfalar)
Sayfayı Yazdır
Universal Serial Bus Printing
Xerox WorkCentre Pro System Administration Guide Supplement
USB Printer Port
The USB Printer Port can be used for printing directly from a
PC connected via a USB cable. USB printing from Windows
98/Me/XP and 2000 is supported. The USB port for printing is
located on the network controller at the back of the machine
on the bottom left hand side, next to the Ethernet port.
Go to the WorkCentre Pro and...
1. Enter the Tools pathway.
a) Press the Access (
b) On the keypad enter 1111 or the current password.
Press Enter. The Touch Screen will be used for the
remainder of the data entry, unless instructed
otherwise.
2. Press More.
3. Press Connectivity and Network Setup.
4. Press Physical Media.
5. Press USB Printer Port.
6. Press Enable.
7. Use the up and down scroll arrows to select the setting
required for the Printer Port Timeout.
NOTE: The default Timeout value is 5 seconds. If you are
using an older PC and experience any print problems, you
may need to increase this value.
8. Press Save.
9. Press Exit Tools.
10. Verify the USB Print Kit has been installed and the USB
Printer Port has been enabled by printing a Configuration
Report. (For instructions click the Network Connectivity
tab and select Configuration Report from the menu list.)
On the Configuration Report, under Device Profile, USB
Printer Port should read Installed and the USB Printer
Port Settings: USB Port Enabled should read Enabled.
or
) button.
Page 1 - 5