Xerox DocuPrint C3055 DX 설정 매뉴얼 - 페이지 14

{카테고리_이름} Xerox DocuPrint C3055 DX에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox DocuPrint C3055 DX 33 페이지. Internal hard disk
Xerox DocuPrint C3055 DX에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지), 설치 매뉴얼 (16 페이지), 설정 매뉴얼 (20 페이지), 설치 매뉴얼 (16 페이지)

페이지 인쇄

2.2

Setting the ESC/P Mode Menu

This section explains the items in the ESC/P mode menu and how to configure them.

ESC/P Mode Menu Items

The items that can be set in the ESC/P mode menu are as follows:

Features Menu

Paper Tray

Sets the paper tray to be used when printing.

The following options are available:

[Tray 1] (default)

[Tray 2]

[Tray 3]

[Tray 4]

[Bypass Tray]

[Auto]

When [Auto] is selected, the printer searches for the paper tray that contains the paper that

matches the [Output Size] setting and automatically feeds paper from that paper tray.

Note

• [Tray 1] - [Tray 4] display the size of the paper loaded in each tray next to the tray names.

• When [Auto] is selected, and if the paper of the same size is loaded in more than one paper tray, the

printer selects a paper tray based on the tray priority setting of a common menu.

• [Tray 2] - [Tray 4] are displayed only if the 500 sheet feeders (optional) are installed.

Output Size

Sets the size of the paper to be used when printing. This can be set only when [Paper Tray]

is set to [Auto] or [Bypass Tray]. Only the sizes for cut sheets can be selected.

The following options are available:

[A4] (default)

[A3]

[A5]

[B4]

[B5]

[11 x 17]

[8.5 x 13] (Available only when [Paper Tray] is set to [Bypass Tray])

[8.5 x 14]

[8.5 x 11]

[100 x 148mm] (Available only when [Paper Tray] is set to [Bypass Tray])

Note

• When [Zoom Mode] is set to [Fixed %] or [Whole Output Size], the printer automatically determines the

zoom ratio based on the [Document Size] and [Output Size] settings.

When [2 Pages Up] is enabled, the zoom ratio will be 1/2 of the zoom ratio determined from [Document

Size] and [Output Size].

• [Output Size] cannot be set when [Paper Tray] is set to [Tray 1], [Tray 2], [Tray 3], or [Tray 4]. The size of

the paper loaded in the paper tray will be displayed.

2 Setting the ESC/P Mode