Xerox Phaser 8200 네트워킹 설정 매뉴얼 - 페이지 32

{카테고리_이름} Xerox Phaser 8200에 대한 네트워킹 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Phaser 8200 47 페이지. Phaser color printer
Xerox Phaser 8200에 대해서도 마찬가지입니다: 트레이 모듈 설치 매뉴얼 (2 페이지), 설치 매뉴얼 (2 페이지), 설치 매뉴얼 (1 페이지), 신속한 릴리스 매뉴얼 (1 페이지), 설치 (1 페이지), 매뉴얼 (2 페이지), 사양 (4 페이지), 서비스 매뉴얼 (11 페이지)

Macintosh EtherTalk Network

This section provides installation and troubleshooting steps for Macintosh (MacOS 8 through X,

version 10.1):

Quick install steps for MacOS 8.x and 9.x — see page 28.

Quick install steps for MacOS X, version 10.1 — see page 30.

Setting up the Macintosh Ethernet port for TCP/IP or AppleTalk — see page 30.

Macintosh troubleshooting step-by-step — see page 31.

A workstation with the appropriate driver installed.

A working knowledge of the operating system (System 8.0+ or higher) being used on your

workstation.

Proper cabling in use to connect your printer to the network.

If you use EtherTalk, Macintosh computers do not require IP addresses.

Open the AppleTalk Control Panel.

Verify that the Ethernet port is the selected network port.

To install the printer driver, double-click the installer on the Software and Documentation

CD-ROM.

Perform the next two steps for MacOS 8.x and 9.x.

Open the Chooser, select the LaserWriter driver.

From the right column of the Chooser, select the printer. Click Create to create the desktop

printer.

Perform the next two steps for MacOS X, version 10.1 only.

Open Print Center.

Click Add Printer, select the printer, then click Add.

For more details, refer to the infoSMART Knowledge Base at

infoSMART, Document #2562.

Phaser® 8200 Color Printer