Xerox Phaser 8200 Handleiding voor netwerkinstellingen - Pagina 32

Blader online of download pdf Handleiding voor netwerkinstellingen voor {categorie_naam} Xerox Phaser 8200. Xerox Phaser 8200 47 pagina's. Phaser color printer
Ook voor Xerox Phaser 8200: Installatiehandleiding voor traymodule (2 pagina's), Installatiehandleiding (2 pagina's), Installatiehandleiding (1 pagina's), Handleiding voor snelle vrijgave (1 pagina's), Installatie (1 pagina's), Handmatig (2 pagina's), Specificaties (4 pagina's), Servicehandleiding (11 pagina's)

Macintosh EtherTalk Network

This section provides installation and troubleshooting steps for Macintosh (MacOS 8 through X,

version 10.1):

Quick install steps for MacOS 8.x and 9.x — see page 28.

Quick install steps for MacOS X, version 10.1 — see page 30.

Setting up the Macintosh Ethernet port for TCP/IP or AppleTalk — see page 30.

Macintosh troubleshooting step-by-step — see page 31.

A workstation with the appropriate driver installed.

A working knowledge of the operating system (System 8.0+ or higher) being used on your

workstation.

Proper cabling in use to connect your printer to the network.

If you use EtherTalk, Macintosh computers do not require IP addresses.

Open the AppleTalk Control Panel.

Verify that the Ethernet port is the selected network port.

To install the printer driver, double-click the installer on the Software and Documentation

CD-ROM.

Perform the next two steps for MacOS 8.x and 9.x.

Open the Chooser, select the LaserWriter driver.

From the right column of the Chooser, select the printer. Click Create to create the desktop

printer.

Perform the next two steps for MacOS X, version 10.1 only.

Open Print Center.

Click Add Printer, select the printer, then click Add.

For more details, refer to the infoSMART Knowledge Base at

infoSMART, Document #2562.

Phaser® 8200 Color Printer