Xerox Phaser 8200 Networking Setup Manual - Page 32

Browse online or download pdf Networking Setup Manual for Printer Accessories Xerox Phaser 8200. Xerox Phaser 8200 47 pages. Phaser color printer
Also for Xerox Phaser 8200: Tray Module Installation Manual (2 pages), Installation Manual (2 pages), Installation Manual (1 pages), Rapid Release Manual (1 pages), Installation (1 pages), Manual (2 pages), Specifications (4 pages), Service Manual (11 pages)

Print Page
Xerox Phaser 8200 Networking Setup Manual

Macintosh EtherTalk Network

(MacOS 8.x/9.x/X, version 10.1)

This section provides installation and troubleshooting steps for Macintosh (MacOS 8 through X,
version 10.1):
Quick install steps for MacOS 8.x and 9.x — see page 28.
I
Quick install steps for MacOS X, version 10.1 — see page 30.
I
Setting up the Macintosh Ethernet port for TCP/IP or AppleTalk — see page 30.
I
Macintosh troubleshooting step-by-step — see page 31.
I

Requirements

A workstation with the appropriate driver installed.
I
A working knowledge of the operating system (System 8.0+ or higher) being used on your
I
workstation.
Proper cabling in use to connect your printer to the network.
I

Enabling EtherTalk

If you use EtherTalk, Macintosh computers do not require IP addresses.
1.
Open the AppleTalk Control Panel.
2.
Verify that the Ethernet port is the selected network port.
3.
To install the printer driver, double-click the installer on the Software and Documentation
CD-ROM.
Perform the next two steps for MacOS 8.x and 9.x.
1.
Open the Chooser, select the LaserWriter driver.
2.
From the right column of the Chooser, select the printer. Click Create to create the desktop
printer.
Perform the next two steps for MacOS X, version 10.1 only.
1.
Open Print Center.
2.
Click Add Printer, select the printer, then click Add.
For more details, refer to the infoSMART Knowledge Base at
infoSMART, Document #2562.
Copyright © 2002 Xerox Corporation. All Rights Reserved.
Phaser® 8200 Color Printer
www.xerox.com/officeprinting/
27