Xerox Nuvera 100 보충 설명서 - 페이지 25

{카테고리_이름} Xerox Nuvera 100에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox Nuvera 100 48 페이지. Production system
Xerox Nuvera 100에 대해서도 마찬가지입니다: 사양 시트 (2 페이지), 기능 설명서 (34 페이지), 계획 매뉴얼 (22 페이지), 사용자 설명서 (40 페이지), 운영 매뉴얼 (34 페이지), 참조 매뉴얼 (2 페이지), 계획 매뉴얼 (20 페이지), 참조 매뉴얼 (42 페이지), 빠른 참조 (2 페이지), 설치 매뉴얼 (2 페이지), 계획 매뉴얼 (38 페이지), 계획 매뉴얼 (16 페이지), 참조 매뉴얼 (2 페이지), 사양 (2 페이지), 힌트 및 팁 매뉴얼 (18 페이지), 힌트 및 팁 매뉴얼 (18 페이지), 시작하기 매뉴얼 (26 페이지), 시작하기 매뉴얼 (30 페이지)

Tape Client Job Submission Guide

Managing and printing jobs from

the Tape Client

This chapter describes the procedures for setting up an offline

LCDS job and submitting it from the Tape Client for printing on

the DocuPrint 2000 Series EPS.

This section contains an overview of the steps to set up and print

an LCDS job from the Tape Client. For further details about each

step, refer to the section that is specified following the step.

1. Make sure that all the resources that the job requires (forms,

fonts, and JDLs) are loaded on the printer in the "lcds"

resources folder.

2. If any resources are missing, import them to the controller

disk from the media on which they reside. (Refer to

"Importing resource files," later in this chapter, for the

procedure.)

3. Load the job tape on your tape drive. Make sure that the tape

is at BOT (beginning of tape). (For instructions on loading

tapes, refer to the Xerox DocuPrint 2000 Series 100/115/135/

155/180 EPS Operator Guide for information on the Xerox

DocuPrint EPS cartridge tape drive, or refer to your tape drive

user documentation.)

4. Open the Tape Client window. (Refer to "Accessing the Tape

Client," in the "Managing the Tape Client" chapter.)

2-1