Clarke Contractor CON750 운영 및 유지 관리 지침 - 페이지 11

{카테고리_이름} Clarke Contractor CON750에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Contractor CON750 20 페이지. Contractor jigsaw
Clarke Contractor CON750에 대해서도 마찬가지입니다: 운영 및 유지보수 지침 매뉴얼 (17 페이지)

페이지 인쇄

2. Adjust the pendulum control to suit the material being cut using the

following suggested settings as a starting point if required. Do not use the

pendulum action for cutting ceramics or metals.

Ceramics

Metal

Plywood, plastics

Timber, fibreboard & chipboard

CUTTING DIFFERENT MATERIALS

CUTTING WOOD

Check that any previously used timber being sawn does not contain any nails

or other metal objects which would damage the blade.

CUTTING METAL

Having chosen a suitable blade for cutting metal it is recommended to

lubricate the material and blade with cutting oil to prevent the tool from

overheating. Support the workpiece with wooden blocks on either side.

ADJUSTING THE SOLE PLATE

The sole-plate is adjustable so that bevels of up to 45° may be cut. Loosen the

two socket head screws under the sole-plate before adjusting it to the

desired angle and re-tightening the screws.

Socket head

screws

MAINTENANCE

CLEANING

1. To ensure constant air circulation, always keep air vents clear of

blockages, (use compressed air to clean the machine if possible).

2. After use, clean all dust and wood chippings from the jigsaw.

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]

1 - 2

1 - 3