Clarke Contractor CON750 Інструкція з експлуатації та обслуговування - Сторінка 11
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та обслуговування для Електроінструмент Clarke Contractor CON750. Clarke Contractor CON750 20 сторінок. Contractor jigsaw
Також для Clarke Contractor CON750: Інструкція з експлуатації та технічного обслуговування (17 сторінок)
Друкувати сторінку
2. Adjust the pendulum control to suit the material being cut using the
following suggested settings as a starting point if required. Do not use the
pendulum action for cutting ceramics or metals.
Ceramics
Metal
Plywood, plastics
Timber, fibreboard & chipboard
CUTTING DIFFERENT MATERIALS
CUTTING WOOD
Check that any previously used timber being sawn does not contain any nails
or other metal objects which would damage the blade.
CUTTING METAL
Having chosen a suitable blade for cutting metal it is recommended to
lubricate the material and blade with cutting oil to prevent the tool from
overheating. Support the workpiece with wooden blocks on either side.
ADJUSTING THE SOLE PLATE
The sole-plate is adjustable so that bevels of up to 45° may be cut. Loosen the
two socket head screws under the sole-plate before adjusting it to the
desired angle and re-tightening the screws.
Socket head
screws
MAINTENANCE
CLEANING
1. To ensure constant air circulation, always keep air vents clear of
blockages, (use compressed air to clean the machine if possible).
2. After use, clean all dust and wood chippings from the jigsaw.
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
11
0
0
1 - 2
1 - 3