Clarke CSA10F 운영 및 유지보수 지침 매뉴얼 - 페이지 8

{카테고리_이름} Clarke CSA10F에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CSA10F 11 페이지. 10 ton hydraulic press

MAINTENANCE

A Visual inspection must be made before each use of the press, checking for

leaking hydraulic fluid, and damaged, loose or missing parts.

Owners and/or users should be aware that repair of this equipment may require

specialised knowledge and facilities. It is recommended that a thorough annual

inspection of the press be made and that any defective parts, decals or warning

labels be replaced with genuine Clarke parts.

Any press which appears to be damaged in any way, is found to be badly worn,

or operates abnormally SHOULD BE REMOVED FROM SERVICE until necessary repairs

are made.

•

Periodically check the press frame to make sure all bolts are tight and inspect

for cracked welds, bent, loose or missing parts.

•

Periodically check the hydraulic connections for possible leaks. Replace or

properly repair damaged or leaking hydraulic components before using.

•

Periodically apply a light smear of oil to the moving parts and the bed support

pins.

•

If oil leaks, caused by a loose union/connection etc., have been repaired,

check the hydraulic pump oil level, by removing the pump from its mounting,

holding it vertically on its nose, and removing the filler/dipstick, shown at 'A',

Fig.1. Top up if necessary to the level on the dipstick, with CLARKE Hydraulic

Oil, Part No. 3050830 only.

This operation is carried out with the ram fully retracted.

•

Replace the Hydraulic oil every TWO years. This operation requires the

dismantling of the hydraulic system, for which you should consult your CLARKE

dealer.