Clarke CSA10F 운영 및 유지보수 지침 매뉴얼 - 페이지 6

{카테고리_이름} Clarke CSA10F에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CSA10F 11 페이지. 10 ton hydraulic press

B. CSA10B

Bolt the feet to the side

members using the nuts

bolts and washers provided.

Bolt on the top and bottom

plates in the manner shown

in fig. 2 , ensuring the bottom

plate is that with the

threaded hole at its centre.

Do not fully tighten the nuts.

Feed the ram assembly

down through the hole in

the top plate and screw it

fully into the threaded hole

in the bottom plate. The

pressure gauge at this point

should be facing the front.

Centralise the ram between

the top rails before

tightening the securing bolts

It is strongly recommended that

the Bench Press be securely

bolted to a sturdy workbench

HYDRAULIC PUMP/RAM OPERATION

The pump is provided with handwheel , which opens or closes a valve in the pump

to raise the ram or lower it under pressure.

Turn the handwheel clockwise and pump the handle to operate (or lower) the

ram. Turning the handwheel anticlockwise releases the pressure and the ram will

rise.

Fig.2