Clarke ZX-R Pro Series 운영 및 유지보수 지침 매뉴얼 - 페이지 6

{카테고리_이름} Clarke ZX-R Pro Series에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke ZX-R Pro Series 9 페이지. 20v cordless multi function tool
Clarke ZX-R Pro Series에 대해서도 마찬가지입니다: 작동, 유지보수 및 사용 설명서 (8 페이지), 운영 및 유지보수 지침 매뉴얼 (17 페이지), 운영 및 유지보수 지침 매뉴얼 (13 페이지), 운영 및 유지보수 지침 매뉴얼 (17 페이지), 운영 및 유지보수 지침 매뉴얼 (17 페이지)

HOW TO CHARGE A BATTERY

WARNING: THE BATTERY CAN BE HOT TO THE TOUCH WHEN REMOVED

FROM THE TOOL. ALWAYS LET THE BATTERY COOL DOWN BEFORE

RECHARGING. DO NOT RECHARGE A HOT BATTERY.

NOTE: New batteries must be charged before use.

1. Connect the battery charger to the power supply.

2. Slide the battery on to the battery

charger until the battery clicks

into position.

3. To remove the battery, push the

latches on each side of the

battery and slide it from the

battery charger.

4. After charging, disconnect the

charger from the power supply.

When the battery pack is secured in the battery charger, the indicator lights

on the battery charger will show the charging status:

Steady

GREEN

Flashing

GREEN

Steady RED

RED and

GREEN lights

both

flashing the

same time

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

Battery is fully charged or no battery is fitted.

Charging and the battery is more than 90% full.

Charging

The battery pack is too hot or too cold for charging (below

0°C/32°F or above 45°C/113°). You should let the battery

pack cool down for approximately 30 minutes before

attempting to recharge.