Clarke ZX-R Pro Series Handleiding voor bediening en onderhoud - Pagina 6

Blader online of download pdf Handleiding voor bediening en onderhoud voor {categorie_naam} Clarke ZX-R Pro Series. Clarke ZX-R Pro Series 9 pagina's. 20v cordless multi function tool
Ook voor Clarke ZX-R Pro Series: Bedienings-, onderhouds- en instructiehandleiding (8 pagina's), Handleiding voor bediening en onderhoud (17 pagina's), Handleiding voor bediening en onderhoud (13 pagina's), Handleiding voor bediening en onderhoud (17 pagina's), Handleiding voor bediening en onderhoud (17 pagina's)

HOW TO CHARGE A BATTERY

WARNING: THE BATTERY CAN BE HOT TO THE TOUCH WHEN REMOVED

FROM THE TOOL. ALWAYS LET THE BATTERY COOL DOWN BEFORE

RECHARGING. DO NOT RECHARGE A HOT BATTERY.

NOTE: New batteries must be charged before use.

1. Connect the battery charger to the power supply.

2. Slide the battery on to the battery

charger until the battery clicks

into position.

3. To remove the battery, push the

latches on each side of the

battery and slide it from the

battery charger.

4. After charging, disconnect the

charger from the power supply.

When the battery pack is secured in the battery charger, the indicator lights

on the battery charger will show the charging status:

Steady

GREEN

Flashing

GREEN

Steady RED

RED and

GREEN lights

both

flashing the

same time

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

Battery is fully charged or no battery is fitted.

Charging and the battery is more than 90% full.

Charging

The battery pack is too hot or too cold for charging (below

0°C/32°F or above 45°C/113°). You should let the battery

pack cool down for approximately 30 minutes before

attempting to recharge.