Zanussi ZHC 95 ALU 지침 책자 - 페이지 17

{카테고리_이름} Zanussi ZHC 95 ALU에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZHC 95 ALU 20 페이지. Cooker hood
Zanussi ZHC 95 ALU에 대해서도 마찬가지입니다: 지침 책자 (20 페이지), 지침 책자 (18 페이지)

페이지 인쇄
Zanussi ZHC 95 ALU 지침 책자
- Remove the plug from the upper part of the ducting fan unit, as it is not
possible to insert the flange F with the plug in place.
- Fit the flange F Ø120 or 150 mm,replace the plug.
· Air outlet directed to the right or left hand side.
- Remove the four screws fastening the plastic frame, as shown in figure .
- Fit the ducting spigot R and replace the four screws removed as above.
Fixing the chimney
a) Loosen the screws M fixing the two parts of the chimney and pull the
inner section I almost all the way out. Remove the protective film P .
b) Rest the lower section of the chimney in its housing on the top of the hood
canopy. Lower the ducting fan unit until it reaches the wall bracket S and
fix it using the screw H provided.Fit the cover D
(provided) on the wall bracket S.
c) Fix the chimney to the hood canopy C using the
four screws provided.
d) Insert the transparent seal Q (provided),so as to
eliminate any play between the two parts of the
chimney . Lock the screws M.
e) Remove the support rod B .
S
A08_21
D
E
E
A08_23
INSTALLATION INSTRUCTIONS
S
A08_22
E
E
H
Q
17
R
I
P
M
A08_20
Q
A08_24