Zanussi ZHI 623 설치, 사용 및 유지보수 핸드북 - 페이지 9

{카테고리_이름} Zanussi ZHI 623에 대한 설치, 사용 및 유지보수 핸드북을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZHI 623 15 페이지.
Zanussi ZHI 623에 대해서도 마찬가지입니다: 설치, 사용 및 유지보수 핸드북 (16 페이지)

페이지 인쇄

EVACUATION BY RECYCLING

- Put the adjustment lever to the recycling position (down) and after installing the

active carbon filter (as described in the installation part of these instructions and in

accordance with the instructions attached to the recycling kit) the recycled air is

discharged through the louvers at the top of the hood facade.

- In this case the hood must be drawn fully down to completely free the facade louvers.

Replacement of the auvent (panel and facade assembled)

- Lift the auvent by its

lower part and

insert the two upper

guide-slides in their

r e s p e c t i v e

housings.

- Pivot the auvent

d o w n w a r d s

inserting the two

lower guide-slides

and tilt the auvent

until it closes.

- Reopen the auvent

to make sure that it

operates correctly

and to check the

presence of the stop at full opening.

- Depending on the weight of the facade, the friction resistance of the auvent may be

adjusted from the inside by means of screws located at the front corners of the

appliance (fig. 9).

- If necessary, make a final alignment with the adjacent furniture by adjusting the

auvent screws supporting the facade.

ELECTRICAL CONNECTION

- Connect the appliance cord to a 10/16 A standard grounded power outlet (2 pins +

earthing pin), preferably located above the hood.

- If the power outlet is not permanently accessible, a 3-pole switch will have to be

provided in the installation with a minimum contact opening of 3 mm.

- The installation shall comply with standard NF C 15.100.

106_10FA