Zanussi ZHI 623 설치, 사용 및 유지보수 핸드북 - 페이지 7

{카테고리_이름} Zanussi ZHI 623에 대한 설치, 사용 및 유지보수 핸드북을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZHI 623 15 페이지.
Zanussi ZHI 623에 대해서도 마찬가지입니다: 설치, 사용 및 유지보수 핸드북 (16 페이지)

페이지 인쇄

2 - Loosen the hexagonal bolts for the

adjustment of the upper suspension hooks

(fig. 6), pull the hooks to the correct

dimension and retighten the bolts.

3 - Loosen the lower spacer plate support bolts

(fig. 7), pull it to the right dimension and

retighten the bolts. This square spacer plate

with built in unequal ribs can be reversed

depending on the required depth.

Auvent preparation

- This hood must be fitted with a facade similar

to that for the furniture in the kitchen and fixed

to the auvent (facade supplied by the furniture

installer).

1 - Fully open the auvent and press the locking

key at the front left inside (fig.5) to completely

remove theauvent.

2 - Drill the starter holes inside the facade using

the drilling template provided for this purpose.

3 - Place the auvent on the panel aligning the

holes and screw in using the screws provided.

Do not put it back on the hood before

installation on the wall.

Wall mounting

- Attach the hood by its suspension hooks to

the support lugs attached to the wall.

- To prevent accidental separation, drill and

attach the two safety brackets (supplied

with the appliance) to the wall so that they

bear on the suspension hooks.

- If necessary, adjust the alignment with the

adjacent furniture using the suspension

hook adjustment bolts (fig. 6).

Additional attachment to adjacent furniture

- Remove the filter support grillage and use the holes visible in the side walls to attach

to adjacent furniture. (The template supplied can be used before wall mounting).