Clarke PIONEER 215 운영 및 유지보수 지침 매뉴얼 - 페이지 12
{카테고리_이름} Clarke PIONEER 215에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke PIONEER 215 12 페이지.
페이지 인쇄
ASSEMBLY
Moving the air compressor
Before moving the compressor, switch off and disconnect it from the mains
power supply.
• Always use the trolley handle.
• Do not lift by (or put strain on) fittings, valves or hoses.
• Take care when moving the compressor to avoid damaging the valves or
fittings.
The compressor is heavy, get assistance when lifting and moving this
compressor to avoid personal injury.
PREPARING FOR USE
Before connecting your compressor to the mains supply,
Check the Oil
1. Lift the dipstick out of the oil reservoir. See figure 2.
2. Ensure the oil level is between the min and max marks on the dipstick. See
figure 3.
• If needed top up the reservoir with Clarke SAE 40 compressor oil,
available from your Clarke dealer.
Figure 2
Figure 3
12
PREPARING FOR USE
Before connecting your compressor to the mains supply, check the following:-
• The mains voltage is 230V.
• The on/off button is in the off position.
• The pressure regulator should be set at its lowest setting, i.e. turned fully
anticlockwise.
• If the machine has not been used for 24 hours or so, open the drain valve
to drain any condensate which may have accumulated. When clear,
close the valve, finger tight.
IMPORTANT: If the receiver is under pressure, keep your hands well away
from the air being expelled. Remember, compressed air is DANGEROUS!
WARNING!
Before connecting any air tool, make sure you have read and fully
understood the manufacturers instruction booklet for the tool being used.
Also ensure that the tool is compatible with the compressor and hose
specifications.
If the pressure rating of the tool is less than 10 bar, the pressure regulator must
be used to adjust the output pressure.
1
Attach the air hose to the air outlet tap
using the hose nut. See figure 4.
• Ensure that the drain valve is finger
tight. For the location of the drain
valve, see page 10.
2
Finally, plug the mains cable into the
supply socket and switch on the power.
Hose nut
Figure 4
On/Off Switch
Figure 5
13