Aleko Victoria Series 설치 및 사용 설명서 지침 - 페이지 11
{카테고리_이름} Aleko Victoria Series에 대한 설치 및 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Aleko Victoria Series 12 페이지. Sizes 6.5x5 8x6.5 10x8
Aleko Victoria Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (20 페이지), 조립 설명서 (14 페이지), 설치 매뉴얼 (17 페이지)
페이지 인쇄
Page 10
Installation of motor bracket: Combine left roller support with motor bracket through bolt
M6 x 50, see Diagram 4 above;
Fixing guide:
1. Please connect the down-lead of the motor and the wire of power supply to the switch
according to the diagram. (Make sure to turn off the power supply first.)
2. The stroke of the motor was placed at the maximum after production.
3. You should turn off the power supply before using the hand crank.
Adjustment:
The motor has two regulation holes, using the screw driver you can adjust the opening
distance of the awning.
-1. Indicating the increase or decrease of the opening of the awning: "+" stands for
increase, "-" for decrease.
-2. Opening direction may be different when the motor is installed, if it is attached
inversely or on the other side. Please check the motor opening direction during
adjustments.
-3. Note: The awning operation is already set during production. If adjusting is needed,
please contact a local dealer or a professional installer.
Attention:
1. The hand crank will not work when the power is turned on. (Important)
2. The awnings driven by the tubular motor have the built-in thermal protection device,
which can keep working for 2 minutes and then stop. After 10 minutes, it will continue to
operate.
3. The built-in tubular motor of awning is suitable for working from -15℃ + 40℃.
4. Do not hang or place any items on any part of the awning.
5. If the motor doesn't work, or the remote control distance is getting short, you should
check the built-in parts of the remote and the batteries.
6. Please check the fixed bracket regularly to make sure they have not come loose,
especially in windy/rough weather areas.
7. The awning should be fully closed in windy conditions.