Aleko Victoria Series 설치 및 사용 설명서 지침 - 페이지 8
{카테고리_이름} Aleko Victoria Series에 대한 설치 및 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Aleko Victoria Series 12 페이지. Sizes 6.5x5 8x6.5 10x8
Aleko Victoria Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (20 페이지), 조립 설명서 (14 페이지), 설치 매뉴얼 (17 페이지)
페이지 인쇄
Page 7
Installation Procedure
1. Measure the distance along the wall where it can be placed. Drill holes for wall
brackets on the wall according to the installation distances and height of the wall brackets.
The diameter and depth of hole must be the same as expansion bolts.
3.5 Inch
Ground
2. Hammer all the expansion bolts into the holes. Then
take down the nuts and washer.
(Note): The expansion bolts must be hammered into the wall
completely.
The bolts must be stick out of the wall so that the wall brackets
can be installed on it.
The nut and washer might be separated from the bolt during
process of transportation, please put them back into their original
positions before hammer them into the wall.)
The holes of each group must be on
the same line in transversal
direction and vertical direction.
(Note: It is recommended to draw
lines on the wall first to ensure
precise position and size of the
holes)
3. Take down the original bolts of the wall
brackets as shown in the figure, use
expansion bolts to fix the wall brackets on
the wall. Do not tighten completely, leave
wall brackets to stay on the wall with little
movement.
*** Make sure all the all bases are on the same
horizontal line.