Clarke EZ-8 운영자 매뉴얼 - 페이지 11
{카테고리_이름} Clarke EZ-8에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke EZ-8 20 페이지. Drum sander
Clarke EZ-8에 대해서도 마찬가지입니다: 운영 및 안전 (2 페이지)
페이지 인쇄
- 1. Table of Contents
- 2. Operator Safety Instructions
- 3. Introduction and Machine Specifications
- 4. How to Transport the Machine
- 5. Machine Set-Up
- 6. How to Operate the Machine
- 7. Sanding Cuts and Sandpaper
- 8. Sander Adjustment Procedures
- 9. Routine Maintenance
- 10. Troubleshooting
- 11. Section II Parts and Service Manual
- 12. Assembly Drawing #1 11/01
- 13. Assembly Parts List #1
- 14. Assembly Drawing #2 10/01
- 15. Assembly Parts List #2 7/03
- 16. Wiring Diagram 9/92
Routine Maintenance
The following items need to be periodically inspected
and maintained to keep your sander in good working
condition.
Sanding Chamber
Periodically blow out the sanding chamber to prevent
large accumulations of debris which could interfere
with the performance of the dust recovery system.
Wheels
Periodically remove the debris from the truck and
caster wheels. Debris can cause waves on a sanded
surface.
Dust Bag
Remove the dust bag from the machine and shake it
thoroughly to remove the sanding dust from the dust
bag. Turn the dust bag inside out and machine wash
in cold water to prevent pore blockage and loss of
dust recovery.
Drive Belt
Periodically check the drive belts for broken cogs or
frayed edges. Frayed edges may indicate poor
tracking. Realign effected belt.
Bearings
Periodically check the bearings for wear or damage
according to the following schedule.
Arbor shaft
Motor shaft
Fan shaft
American Sanders EZ - 8 Sander Operator's Manual
Clarke
®
Relubricate every 150
hrs. w/.10 oz. of a NLGI
grade 2, -30
F to 250
F,
0
0
58-75 SUS at 210
F,
0
grease lubricant.
after 1
5000 hrs.
st
After first 1500 hrs.
Page 11