Clarke EZ-8 운영자 매뉴얼 - 페이지 9

{카테고리_이름} Clarke EZ-8에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke EZ-8 20 페이지. Drum sander
Clarke EZ-8에 대해서도 마찬가지입니다: 운영 및 안전 (2 페이지)

페이지 인쇄

Sanding Cuts and Sandpaper

Initial Cut

The purpose of the initial cut is to remove old finish and gross imperfections on the floor surface. A coarse

abrasive should be used. If the surface is severely damaged by deep scratches, pre-existing dwell marks,

uneven planks, etc., it may be necessary to sand across or diagonally to the grain to restore evenness to the

surface. If these conditions are not present, the initial cut should be done in the direction of the grain.

If glazing, loading, or burning takes place immediately into an initial cut, select a coarser abrasive. If this

should occur during an initial cut, the abrasive has dulled and must be replaced.

Final Cuts

The purpose of a finishing cut is to remove the scratches produced during the initial cut. Use a fine (60 - 80

grit) grain abrasive.

If the surface remains rough after a finishing cut, it may be necessary to use an even finer grain of abrasive (80

- 100 grit). Care should be taken in selecting the grit size of the abrasive. A very fine grain will close the

pores on a wood floor making admission of a stain difficult.

If glazing or burning should occur immediately into a finishing cut, increase pace. If it should occur during a

finishing cut, the abrasive has dulled and must be replaced.

Grain

Use

12 grit

For removing gross imperfections and restore

16 grit

evenness to old flooring. To remove build-up of

20 grit

paints and varnishes

24 grit

36 grit

For the first sanding of new flooring (maple, oak).

40 grit

For removing minor imperfections and finishes

from old flooring.

50 grit

For first sanding of new flooring (cedar, pine, fir)

For clean-up of 16 grit.

60 grit

For clean-up from initial cut 36 grit.

80 grit

For final sanding of certain hardwoods. For

clean-up of initial cuts (50 grit).

100 grit

For final sanding of certain hardwoods and

conifers where a smooth surface is desired.

American Sanders EZ - 8 Sander Operator's Manual

Clarke

8 x 18

Sheet 8x 19 Sleeve

Part No./ Cnt.

Cloth Back

Part No./Cnt.

945390/25

945391/25

945392/25

945930/10

945395/25

945933/10

945397/25

945398/25

945935/10

945399/25

945936/10

945400/25

945937/10

8 x 18

Sleeve

Paper Back

Part No./Cnt.

945416/10

945418/10

945420/10

945421/10

945422/10

Page 9