Clarke EZ-8 운영자 매뉴얼 - 페이지 12
{카테고리_이름} Clarke EZ-8에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke EZ-8 20 페이지. Drum sander
Clarke EZ-8에 대해서도 마찬가지입니다: 운영 및 안전 (2 페이지)
페이지 인쇄
- 1. Table of Contents
- 2. Operator Safety Instructions
- 3. Introduction and Machine Specifications
- 4. How to Transport the Machine
- 5. Machine Set-Up
- 6. How to Operate the Machine
- 7. Sanding Cuts and Sandpaper
- 8. Sander Adjustment Procedures
- 9. Routine Maintenance
- 10. Troubleshooting
- 11. Section II Parts and Service Manual
- 12. Assembly Drawing #1 11/01
- 13. Assembly Parts List #1
- 14. Assembly Drawing #2 10/01
- 15. Assembly Parts List #2 7/03
- 16. Wiring Diagram 9/92
Troubleshooting
Problem
Drive belts jump teeth or squeak.
Squealing, growling or grinding
noise coming from machine.
Dust pick-up is poor.
Motor will not start.
Motor runs sluggishly.
Motor overload trips/repeatedly
trips
Uneven cut.
Burning or glazing.
Waves on sanded surface.
Page 12
Cause
Damaged belt.
Insufficient tension.
Poor belt tracking.
Damage and/or worn bearing.
Dust bag is over
/
full.
1
3
Dust bag is dirty.
Dust shoe is improperly adjusted.
Dust chute is obstructed.
Defective motor starter.
Defective start capacitor.
Defective start switch.
Poor connections.
Motor overload tripped.
Defective motor.
No power.
Low voltage from excessive length,
undersized extension cord, or poor
connection.
Defective run capacitor.
Defective motor.
Low voltage from excessive length,
undersized extension cord, or poor
connection.
Excessive load.
Defective start switch.
Defective motor starter.
Defective motor.
Defective capacitor.
Leveling out of adjustment.
Dull abrasive.
Too fine of an abrasive.
Debris on wheels.
Flat spot on tire(s).
Clarke
Action
Replace belt.
Tension drive belt.
Align Pulley.
Remove drive belts, rotate arbor
motor and fan shafts to locate
dragging or rough bearing.
Contact an authorized Clarke
American Sanders dealer.
Empty contents of bag.
Shake debris from bag and wash.
Readjust dust shoe.
Remove dust shoe and clear throat.
Contact an authorized Clarke
American Sanders dealer.
Contact an authorized Clarke
American Sanders dealer.
Contact an authorized Clarke
American Sanders dealer.
Check connections.
Remove power. Depress reset
button on motor
Contact an authorized Clarke
American Sanders dealer.
Check power supply and connections.
Locate power source nearer to work
site. Check connections.
Contact an authorized Clarke
American Sanders dealer.
Contact an authorized Clarke
American Sanders dealer.
Remove power, allow motor to cool.
Depress reset button on motor.
Locate power source nearer to
worksite. Check connections.
Contact an authorized Clarke
American Sanders dealer.
Contact an authorized Clarke
American Sanders dealer
Contact an authorized Clarke
American Sanders dealer.
Contact an authorized Clarke
American Sanders dealer.
Contact an authorized Clarke
American Sanders dealer.
Contact an authorized Clarke
American Sanders dealer.
Readjust leveling.
Replace abrasive.
Use a coarser abrasive.
Remove and clean wheels.
Replace tires.
American Sanders EZ - 8 Sander Operator's Manual
®