Clarke 6499642 조립 및 유지보수 지침 - 페이지 2

{카테고리_이름} Clarke 6499642에 대한 조립 및 유지보수 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6499642 4 페이지. Strong chemical vane pump

ASSEMBLY

FITTING THE PUMP TO A BARREL

1. Assemble the pump using the required number of inlet tubes. Use the PTFE tape at all connections

• The tube which contains the black fiter + mesh should be at the bottom.

2. Screw the collar into the threaded opening of the barrel.

3. Raise or lower the inlet tube so that it is just off of the bottom of the barrel when fitted.

USING THE PUMP

1. Make sure all connections are secure and place a suitable container under the spout.

2. Rotate the handle to draw fluid from the barrel.

• The first time you use the pump, liquid should begin flowing after several turns of the handle

MAINTENANCE

CLEANING THE INLET FILTER

1. Unscrew the inlet filter from the bottom of the inlet tube and clear away any debris it has trapped.

2. Replace the filter.

CAUTION: DO NOT USE THE PUMP WITHOUT THE FILTER IN PLACE.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

WHAT IS SUPPLIED

ASSEMBLED