Clarke CON14110 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke CON14110에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CON14110 17 페이지. 355mm 110 v abrasive cut-off saw

UNPACKING AND ASSEMBLY

Unpack the saw carefully and ensure that the following items are in the box. In

the event of any deficiencies you should contact your CLARKE dealer

immediately.

• Abrasive Cut-off Saw

• 355mm Cutting disc (supplied fitted)

• 8mm Hexagon Wrench

To unlock the saw and raise the motor

arm.

1. Push down on the handle (1).

2. Pull the locking pin out slightly (2) to

unlock the motor arm.

3. Release the pressure on the handle.

• The motor arm will then raise into

position.

• Reverse this process when locking the motor arm down for storage.

• Angle iron should be clamped and cut with both edges resting

against the base of the saw.

• A spacer block slightly narrower than the workpiece can be used to

raise the workpiece if required.

• A long workpiece must be supported by a block so that it will be

level with the top of the base. The cut-off end should be free to fall

downward to avoid binding against the wheel.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]