Clarke CON14110 운영 및 유지보수 지침 매뉴얼 - 페이지 8

{카테고리_이름} Clarke CON14110에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CON14110 17 페이지. 355mm 110 v abrasive cut-off saw

OPERATION

VICE OPERATION

1. Turn the handle counterclockwise

to remove clamping pressure.

2. Lift the vice lever up.

3. Pull the handle out as far as

desired.

• The vice may be pushed forward

into the work without turning the

handle.

4. Lower the vice lever then tighten the vice on to the workpiece using the

handle.

1. To start the saw, pull the trigger

switch.

• Wait a couple of seconds until

the blade reaches full speed.

2. To turn the saw off, release the

trigger switch.

• Keep hands and materials away

from the wheel until it has come

to a complete stop.

The motor is protected against

overload by an overload cut-out. If the

rated current is exceeded, the

overload cut-out switches the saw off.

After a short cooling-off phase, the

saw can be reset by pressing the

overload switch.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]