Clarke CON14110 운영 및 유지보수 지침 매뉴얼 - 페이지 10

{카테고리_이름} Clarke CON14110에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CON14110 17 페이지. 355mm 110 v abrasive cut-off saw

TO CHANGE THE SPACING BETWEEN THE FENCE AND VICE

1. Use the wrench provided to loosen

and remove the two fence bolts.

2. Adjust the fence to the desired

position.

3. Replace the fence bolts and

tighten securely before use.

The depth stop is set at the factory for

a new 14" (355mm) cutting disc. This

can be adjusted as the wheel wears.

1. Loosen the jam nut.

2. Loosen the depth stop bolt.

3. Adjust the bolt to desired height.

4. Then turn the jam nut until seated

firmly against the casting.

• Securely tighten the depth stop bolt before use.

CAUTION: WHEN CHANGING TO A NEW CUTTING DISC, RE-ADJUST THE

DEPTH STOP TO THE ORIGINAL POSITION TO PREVENT CUTTING INTO THE

SUPPORTING SURFACE.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]