Clarke CON14110 운영 및 유지보수 지침 매뉴얼 - 페이지 6

{카테고리_이름} Clarke CON14110에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CON14110 17 페이지. 355mm 110 v abrasive cut-off saw

ELECTRICAL CONNECTIONS (110V ONLY)

WARNING! READ THESE ELECTRICAL SAFETY INSTRUCTIONS

THOROUGHLY BEFORE CONNECTING THE PRODUCT TO A

POWER SUPPLY.

This product can be connected to one of the following power supplies:

• 110V Generator, 110V Isolating Transformer or 110V Site supply

Connecting it to any other power source may

cause damage.

This product includes a fitted industrial plug to BS-

EN 60309, and a cable for use with a 110 volt

supply.

ON NO ACCOUNT MUST A 230V, 13AMP (BS1363)

PLUG BE USED.

If using a portable 110V transformer make sure it

has a rated capacity sufficient to take the load of

the saw.

If the plug needs changing at any time, a plug of

identical specification must be used:

1. Undo the socket screws & remove the rear

section.

2. Rotate the cable clamp clear of the terminals.

3. Feed the cable through the rear gland in the

plug.

4. Remove the cable sheath to the required lengths as shown in the diagram.

5. Terminate the correct wires in the

correct terminal blocks as shown.

6. Remove the cable clamp screws. Clip

the cable clamp back into position and

place the clamp around the outer

sheath of the cable. Replace the screws

and tighten until the cable is secure.

7. Replace the rear cover and tighten the

cover screws.

If in any doubt, consult a qualified electrician. DO NOT attempt any repairs

yourself.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]