Clarke CRS350M 운영 및 유지보수 지침 매뉴얼 - 페이지 8

{카테고리_이름} Clarke CRS350M에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CRS350M 13 페이지. Mini reciprocating saw

TO STOP THE SAW

1. Release the trigger when not using the trigger lock feature. If using the

trigger lock function, press and release the trigger.

WARNING: THE BLADE WILL CONTINUE TO RUN FOR A SHORT PERIOD

AFTER THE TRIGGER HAS BEEN RELEASED WAIT UNTIL IT STOPS BEFORE

REMOVING IT FROM THE WORKPIECE.

WARNING: IF THE CUTTING OPERATION IS DUSTY, WE RECOMMEND THAT

YOU USE A DUST

• Allow the tool to reach full speed before touching the work material.

• Guide the saw blade into the workpiece keeping the Shoe pressed

firmly against the workpiece while cutting to prevent tool kickback.

• Do not press too hard, if the saw slows down as it is cutting, apply less

pressure.

• Allow the tool to come to a complete stop before setting it down.

• To prevent accidents, turn off the tool and disconnect its power

supply after use. Clean, then store the tool indoors out of the reach

of children.

Plunge cut into plywood and thin board panels. Do not attempt to plunge cut

into thick, hard wood or metal panels.

1. Clearly mark the line of cut.

2. From a convenient starting point within the cutting area, place the tip of

the blade over that point with the saw parallel to the line of cut.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

MASK.