Clarke CRS350M 운영 및 유지보수 지침 매뉴얼 - 페이지 9

{카테고리_이름} Clarke CRS350M에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CRS350M 13 페이지. Mini reciprocating saw

3. Place the edge of the pivot shoe

on the work piece with the blade

NOT touching the work material.

• Never start a plunge cut with

the blade tip touching the work

piece. this will cause an

immediate kick back, that can

damage the work piece, blade

or cause injury.

4. Squeeze the trigger, when the saw

reaches full speed, slowly rotate the tool on the pivot shoe until the blade

has penetrated through the work material

• Hold the tool firmly.

5. Press the pivot shoe firmly against the work material and continue to make

the cut.

CUTTING METAL

1. Install a metal cutting blade.

2. Coat the cutting surface with cutting oil to prevent the blade from

overheating.

• Follow general cutting procedure above.

WARNING: BEFORE PERFORMING ANY MAINTENANCE TASKS MAKE SURE

THAT THE MAINS PLUG HAS BEEN REMOVED FROM THE MAINS SUPPLY.

• After use, clean all dust and wood chippings from the reciprocating

saw.

• Clean all of the ventilation slots on the motor housing.

• Make sure that the shoe is free from dirt and grease.

• Keep the handle clean and free from oil and grease.

• Resin and glue on the blade causes poor cutting results. Clean the

blade after use.

• Refer to your CLARKE dealer if internal maintenance is required.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]