Clarke 6925500 운영 및 유지보수 지침 매뉴얼 - 페이지 10

{카테고리_이름} Clarke 6925500에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6925500 17 페이지. Infrared diesel heater

5. Fit the stand to the fuel tank using

the fixings supplied. Note the

correct orientation.

SUITABLE FUELS

Diesel or paraffin are the only fuels

that should be used in this heater.

IMPORTANT: In cold weather,

condensation may develop in the tank if the tank is empty. Before filling the

fuel tank for the first time or after extended storage periods, vent the fuel

tank of any moisture or condensation.

1. Follow all of the "Safety Precautions".

2. Remove the fuel cap.

NOTE: If you lose the fuel cap a

replacement must be

obtained before use, this is

available from the Clarke

service department.

3. Fill the fuel tank with clean diesel

or paraffin.

4. When refilling, inspect the mesh

filter inside the filler neck for any

trapped contamination and clean out if necessary.

• When filling the heater, make sure that the heater is level and do not

overfill. Use a funnel or can with a long filling spout.

• Fill with a minimum of 4 litres of fuel.

The heater should not be used in habitable areas. It must be located on a

hard, level surface to minimise the risk of accidentally tipping over. The heater

is not suitable for use on wood floors or other combustible materials. It should

be stood on suitable insulating material at least 26 mm thick and extending

1m or more in all directions.

When the heater is in use, periodically monitor any buildup of heat on nearby

surfaces.

It is important that the heater is positioned with at least 2.5 m clearance at the

front between the heater and any objects or surfaces. Always position the

heater facing the centre of the room, not pointing directly at any nearby

surfaces. Never place any objects on, or against the heater.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]