Clarke 6925500 운영 및 유지보수 지침 매뉴얼 - 페이지 11

{카테고리_이름} Clarke 6925500에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6925500 17 페이지. Infrared diesel heater

Any equipment or workshop furniture should be a safe distance away as they

could be adversely affected by heat.

VENTILATION

The heater must only be installed in a room which is well ventilated. Ventilation

is essential to reduce the dangers of carbon monoxide poisoning.

OPERATION

1. Plug the heater into the mains

power supply.

2. Set the power switch to the ON

position.

• The 'power-on' LED will

illuminate and the digital

temperature display will show

the room temperature for up to

3 minutes.

• Turn the temperature control

knob to adjust the target temperature required. This setting will be

shown by the digital display.

NOTE: If the heater does not start up, the temperature control may be set too

low. Turn the control knob to a higher setting until the heater starts. If

the heater does not start, switch the power switch off, then switch back

on again. If the heater still does not start, refer to fault-finding guide on

page 13. Also check that the power supply is correct.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]